1.1

by Linda Vanasupa

Sample Preparation

Written By: Cory Hughes (and one other contributor)
  • Comments: 0
  • Favorites: 0

Difficulty

Very easy

Steps

2

Time Required

00:05:00 - 00:07:00

Sections

1

Flags

0

Introduction

Use the ASTM guide to take measurements on the relevant dimensions of your test specimen.

  1. ASTM Standard D638 outlines the methods for tensile testing of plastics Section 6 of the standard details the geometry of the samples being tested

    • ASTM Standard D638 outlines the methods for tensile testing of plastics

    • Section 6 of the standard details the geometry of the samples being tested

    • measure each sample to ensure that they fall within the defined dimensions in standard D638

    • Take note of any deviations so that the dimensions can be adjusted in the Instron software

    • Features such as the grips and the machine's displacement rate are specific to testing plastics and therefore also outlined in standard D638

  2. Samples should be flat and free of any damage to the gauge length, which could compromise the test.

    • Samples should be flat and free of any damage to the gauge length, which could compromise the test.

    • Refer to the standard operating procedure for proper loading of each sample prior to tensile testing.

Finish Line

Author

with 1 other contributor

Cory Hughes

Member since: 09/28/2015

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 4

Past 30 Days: 8

All Time: 769

Creative Commons License
Materials Engineering Equipment Safety by The Cal Poly MatE Community is licensed under a Creative Commons Attribution 4.0 International License.
Based on a work at http://matecalpoly.dozuki.com/.